Lubrication reservoir pumps serve a multitude of purposes in industrial manufacturing processes. If you have one of these pumps on your assembly line, getting to know its functions and features is a necessity. These pumps have a full lineup of automated features to make using them as simple and straightforward as possible. The higher-end models, such as Vogel lubrication pumps, tend to have more automated features than the most basic units on the market. Here is a look at some of the things most lubrication reservoir pumps can do automatically without user input. 

The pressure switch function closes when pressure builds up. 

In order for fluid to move around in the reservoir of the pump and properly coat everything, air pressure must be at a satisfactory level. Each pump is outfitted with a pressure switch that will automatically close when the pressure inside of the reservoir gets to where it needs to be. Likewise, if the air pressure builds up too much, the pressure switch will change to allow some of that pressure out so it does not generate problems. In some cases, the pressure switch will have to be reset to properly function once the unit has turned off mid-operation. 

The low-level shut-off valve turns off the unit when oil levels are low. 

Oil levels inside of the reservoir are consistently monitored, and there is a valve inside of that reservoir that monitors the levels of fluids inside. In the event the oil levels get too low, the sensor sends a signal to the motor to disrupt its operation. The pump should not be operated when there are low fluid levels because it can generate too much friction and heat as the pump works. If your unit kicks off because fluid levels are too low, simply cut the power and add fluid as needed to refill the reservoir and the pump should come right back on. 

The heat sensor shuts down the pump if it gets too hot. 

Just like many other types of equipment, the lubrication reservoir pump cannot function safely when it gets too hot. Therefore, the majority of the units do have heat sensors that detect when the pump is too hot. If too much heat is detected, the pump gets immediately shut down. In order for the unit to come back on, you will likely have to hit the reset switch once the pump has completely shut down. 

For more information, get in touch with a company like The Buckman Group, Inc.